QE2 Remote Controller

Lock Function Instructions

1. Function Description

To prevent accidental operation, the remote controller can lock the trim buttons/mixing button/high/low rate button/channel reversal button.

2. Setup Method

A. Press and hold the remote controller's 【Lock Button】 for 1 second to enable the lock function; an icon will appear on the display. The method for enabling and disabling the lock is the same.

Automatic Shutdown Instructions

1. Function Description

To prevent the remote controller from being left on, it will shut down after 15 minutes without any operation. An audible prompt will sound 1 minute before shutdown.

Channel Reversal Instructions

1. Function Description

This remote controller allows the direction of Channel 1/Channel 2/Channel 3/Channel 4 to be reversed.

2. Setup Method

A. Press and hold the remote controller's 【Channel Reversal Button】 for 1 second to enter setup mode; the remote controller will emit an audible prompt, and the power indicator will flash at the same time;

B. Move the stick for the corresponding channel to toggle the channel direction 【move the stick in any direction】.

【Note: The direction of only one channel can be configured at a time.】

High/Low Rate Instructions

1. Function Description

To make the remote controller easy for beginners to operate, the travel range for Channel 1/Channel 2/Channel 4 can be switched. The default high travel range is 100% 【1000-2000】, and the low travel range can be set to 70% 【1150-1850】.

2. Setup Method

A. Press and hold the remote controller's 【High/Low Rate Button】 for 1 second to switch between the high and low rates; an icon will appear on the display.

Channel 1/2 Mixing Instructions

1. Function Description

Channel 1/Channel 2 mixing is also commonly known in aeromodelling as 【delta-wing mixing】.

2. Setup Method

A. Press and hold the 【Mixing Setup Button】 on the panel for 1 second to switch the mixing mode. The display icon 【①】 indicates Channel 1/2 mixing mode.

【Note: Mixing modes are switched cyclically using a single Mixing Setup Button.】

Channel 2/4 Mixing Instructions

1. Function Description

Channel 2/Channel 4 mixing is also commonly known in aeromodelling as 【V-tail mixing】.

2. Setup Method

A. Press and hold the 【Mixing Setup Button】 on the panel for 1 second to switch the mixing mode. The display icon 【②】 indicates Channel 2/4 mixing mode.

【Note: Mixing modes are switched cyclically using a single Mixing Setup Button.】

Battery Usage Instructions

1. Usage Instructions

The remote controller is powered by the paired data transmission ground module. When the ground module is powered on, the remote controller turns on automatically.