LQ-10 Accessory Instructions
Document Purpose : This manual is intended to guide users in using the LQ 10 core board for communication.
2 min read · English documentationDocument Purpose: This manual is intended to guide users in using the LQ-10 core board for communication.
Safety and Precautions
Operational Safety: Avoid use in environments with extreme temperatures, high humidity, or strong magnetic fields, and prevent liquids from entering the device.
Electrical Safety: Use a standard ultra-fine coaxial cable for the connection, and the supply voltage must not exceed 9V ~ 15V.
Storage Safety: When not in use, the product should be stored in a dry, dust-free environment.
Package Contents
- LQ-10 core board
- Ethernet adapter cable
- Ethernet adapter
Installation and Connection Guide
-
Snap the LQ-10 core board into FlyCore's core-board connector, and connect the Ethernet cable connector to the external Ethernet port on the baseboard.
-
First mate the feeder cable connector with the antenna, and then snap the entire assembly into the antenna connector until you hear a click.
- Connect one end of the Ethernet adapter cable to the gigabit Ethernet port on the flight controller board and the other end to the Ethernet adapter. Then connect an Ethernet cable between the adapter and the PC to enable network communication. Either of the two leads branching from the Ethernet adapter cable shown below can be used directly for network communication.
Before using web-based communication, set the PC to an IP address on subnet 1; otherwise, communication cannot be established.
Usage Guide
Because the LQ-10 core board is used, refer directly to the official LQ-10 core board documentation for detailed operating instructions. Users only need to study Section “2.3.1 Configuration Guide.” LQ-10 Wiki address: https://docs.amovlab.com/amov-lq10-wiki/
