Documentation/LQ-10 Video/Data Transmission Module WikiEnglish · V1
Browse documentation
Support and Services

Change Log

2026.03.08: Released LQ 10 firmware V1.0.0, adding point to point networking, star networking, serial communication, Ethernet UDP/TCP, SBUS, firmware updates, STP, MSS clamping,…

1 min read · English documentation

Change Log

Initial Release

  • 2026.03.08: Released LQ-10 firmware V1.0.0, adding point-to-point networking, star networking, serial communication, Ethernet UDP/TCP, SBUS, firmware updates, STP, MSS clamping, multicast communication, and broadband/narrowband switching.

Subsequent Updates

  • 2026.06: Network and serial-port configurations support runtime application and rollback after failure, without restarting the application.
  • 2026.06: Added an AP/STA device discovery protocol and UDP AT configuration interface.
  • 2026.06: Added both WPA2-PSK and Open security modes, with improved validation for the SSID, password, IP address, port, and serial-port parameters.
  • 2026.06: Broadband APs support dynamic selection of 20/40/80MHz; the setting remains read-only on STAs.
  • 2026.06: UART0 SBUS was updated to 100000 8E2, with inversion controlled automatically by the hardware.
  • 2026.06: The Device Status page displays both AP/STA addresses and bidirectional RSSI, and identifies the current STA.
  • 2026.06: Flashing the RSSI indicator red is now based on link-reporting timeouts and is no longer triggered directly by a low RSSI threshold.
  • 2026.06: Added Chinese/English switching and versioned cache updates to the web interface.
  • 2026.06: Resolved the MTU issue. IP packets of up to 1500 bytes are supported. (Packets will be fragmented; a data size of 1400 bytes is most strongly recommended for users.)